Three-Dimensional Cubic Display and Lattice Analysis Using 89C51 Microcontroller

Authors

  • Abhishek Kumar Singh Ganga Institute of Technology and Management, Kablana, Haryana
  • Rakesh Joon Ganga Institute of Technology and Management, Kablana, Haryana

DOI:

https://doi.org/10.37628/jeset.v3i2.653

Abstract

A three-dimensional display has been presented in this paper which is driven by a microcontroller. A new form of display has been introduced in the LED arena. Any size cube of A*A*A can be effectively implemented which are cheap as well as rugged. A three-dimensional mosaic of light emitting diode is formed in a cube which is comprised of light emitting diodes arranged in the dimensional matrix. Cheapness and ruggedness is result of the simplicity of this design.

Author Biographies

Abhishek Kumar Singh, Ganga Institute of Technology and Management, Kablana, Haryana

Department of Electronics and Communication Engineering

Rakesh Joon, Ganga Institute of Technology and Management, Kablana, Haryana

Department of Electronics and Communication Engineering

References

A. Gago-Horquez. MultiColor virtual matrix LED display controlled using D-TYPE FLIP FLOP drivers, J Display Technol. 2011; 7: 174p.

S.-M. Liu, K.-C. Chou. The design and implementation of a low cost 360 degree color LED display system, IEEE Trans Consum Electron. 2011; 57(2).

D. Yanchuang, G. Jinying. LED display screen and proteus simulation based on single chip microprocessor, 2nd Int. Conference (ICIECS). 2010; 1(4): 25–6p.

C.-H. Wei, P.-N. Bui. Implementing a web based remote controlled system for LED dot matrix display”.

Downloads

Published

2018-01-23

Issue

Vol. 3 No. 2 (2017)

Section

Articles