Simulation and Design of Closed Loop Controlled Buck - Boost Converter

Authors

  • Abhijeet Bhattacharya Student , Department of Electrical Engineering , Bharati Vidyapeeth’s College of Engineering, Paschim Vihar, New Delhi
  • Sandeep Banerjee Assistant Professor, , Department of Electrical Engineering Bharati Vidyapeeth’s College of Engineering, Paschim Vihar, New Delhi
  • Saksham Girotra Student , Department of Electrical Engineering , Bharati Vidyapeeth’s College of Engineering, Paschim Vihar, New Delhi
  • Gaurang Bhardwaj Student , Department of Electrical Engineering , Bharati Vidyapeeth’s College of Engineering, Paschim Vihar, New Delhi
  • Hridesh Shukla Student , Department of Electrical Engineering , Bharati Vidyapeeth’s College of Engineering, Paschim Vihar, New Delhi

Abstract

In this paper we propose to model some practical power electronic converters used in the intermediate power conversion process for e.g. wind, solar, and battery system. The small-signal models are derived from the differential equations. Based on the models, simulation and experimental results is be provided to validate the proposed controllers. A mathematical and simulation model of a practical Buck-Boost converter is developed, it will be employed for closed loop voltage control of a DFIG DC system through MATLAB/Simulink. This ideology is be verified upon a hardware setup with a microcontroller.

References

Narsardin, M. A. M. (2012). Voltage Tracking of a DC-DC Buck Converter Using Neural Network Control (Doctoral dissertation, Universiti Tun Hussein Onn Malaysia).

Abhijeet Bhattacharya, Sandeep Banerjee, Saksham Girotra, Hridesh Shukla, Gaurang Bhardwaj, Sidharth Talia. Simulation and Design of PI-Controller for the Control of Buck Converter. Journal of Microelectronics and Solid State Devices. 2020; 7(1): 26–33p.

Y. Wang, D. Yu and Y. Kim, ”Robust Time-Delay Control for the DC–DC Boost Converter,” in IEEE Transactions on Industrial Electronics, vol. 61, no. 9, pp. 4829-4837, Sept. 2014, doi: 10.1109/TIE.2013.2290764.

Stephen, S. B. J., amp; Devaprakash, T. R. (2011, Decem- ber). Improved control strategy on buck- boost converter fed DC motor. In 2011 International Conference On Recent Advancements In Electrical, Electronics And Control Engineering (pp. 73-77). IEEE.

Algamluoli, A. F. (2019, June). Novel Controller for DC- DC Cuk Converter. In 2019 1st Global Power, Energy and Communication Conference (GPECOM) (pp. 117-121). IEEE.

Ushakumari, S., amp; Mithila, A. K. (2017, July). Design of robust sliding mode and fuzzy logic controllers for boost and buck-boost converters. In 2017 International Conference on Intelligent Computing, Instrumentation and Control Technologies (ICICICT) (pp. 463-468). IEEE.

Rajeswari, R. V., amp; Geetha, A. (2014). Comparison of Buck-boost and CUK converter control using fuzzy logic controller. Int. J. Innov. Res. Sci. Eng. Technol, 3(3).

ALgamluoli, A., amp; Mahmood, M. F. Controller for Boost Converter in S-domain and Z-Domain by using SISOTOOL MATLAB. International Journal of Computer Applications, 975, 8887.

Chen, Jingquan Maksimovic, Dragan Erickson, Robert. (2001). Buck-boost PWM converters having two indepen- dently controlled switches. PESC Record - IEEE Annual Power Electronics Specialists Conference. 2. 736 - 741 vol.2. 10.1109/PESC.2001.954206.

Dinc a˘, L. and J. Corcau. “P.I. versus fuzzy control for a DC to DC boost converter.” 2016 International Symposium on Power Electronics, Electrical Drives, Automation and Motion (SPEEDAM) (2016): 803-808.

Downloads

Published

2021-09-04

Issue

Vol. 7 No. 1 (2021)

Section

Articles